Microcement Installation and Application Services
Semiforêt provides microcement material supply and installation for project applications in Singapore. Our 15-step process guides the work from surface preparation to final protection, so each project is approached as a complete microcement system rather than only a decorative topcoat.
Microcement Installation in Singapore
Semiforêt provides microcement application services for floors, bathrooms, walls, stairs and selected custom surfaces in Singapore.
Our application system is designed around proper substrate assessment, base preparation, reinforcement where required, controlled layering, finish consistency and sealed surface protection.
Because microcement is a thin decorative surface system, the final result depends heavily on the condition of the existing substrate and the quality of each application step. Before installation, we assess the project area, surface type, moisture risk, cracks, hollow tiles, transitions, corners and wet-area requirements.
Standard 15-Step Application System
Technical Evidence Should Be Read With Context
Selected third-party laboratory reports are available for reviewed samples and stated test methods. Results should be interpreted together with the tested sample, report scope, substrate condition, application, detailing, protective finish and curing. Original reports remain the governing documents for formal verification.
Review Technical Evidence
Completion Standards
Primer is applied according to system requirements.
Reinforcement mesh is installed where required.
The substrate must be properly covered and prepared before finish layers begin.
1. Base Preparation
Completion Standards
A good microcement project should be assessed not only by colour and texture, but also by base preparation, edge treatment, junction quality, sealer completion and final site cleanliness.
Our handover standard focuses on visual consistency, neat transitions, completed sealing and practical readiness for daily use.
2.Surface Finish
Finish coats are applied to the required number of layers.
Internal and external corners should appear visually neat and consistent.
Shadow gaps, wall-floor junctions, and transitions should be visually straight and clean where specified.
No obvious large-area colour inconsistency, exposed base, or material sagging should be visible under normal inspection.
Sealer must be fully completed.
The finished surface should be clean and free from obvious construction dirt.
Site waste should be cleared before handover.
The final visual effect should remain consistent with the approved sample within normal handcrafted tolerance.
3.Sealer and Final Handover
Choose Your Microcement Application
Explore the application page that best matches your project. Each page explains the relevant surface context, substrate considerations and the information needed for an initial assessment.
Contact Us
Hours
Monday–Saturday
9:00 AM – 5:00 PM
+65 86957100
Location
73 Ubi Road 1
(Oxley Bizhub Tower 1 #07-54)
Singapore 408733
